Kaiyi BR380JG-1E0 — E-15 THE CRUSHER CLEARANCE ADJUSTMENT MODE DOES NOT CHANGE

SEN02095-00 40 Troubleshooting E-15 The crusher clearance adjustment mode does not change 1 30 BR380JG-1E0 Trouble • When the clearance adjustment selector switch is changed, the current mode does not change.

Relative information • Clearance adjustment selector switch (The clearance selector (full auto) or clearance selector (auto) of switch input 5 can be checked with the machine monitoring function (See Table below) Mode Clearance adjustment selector (automatic) Clearance adjustment selector (semi-automatic) Manual OFF OFF Semi-automatic OFF ON Automatic ON ON • Check if failure code for abnormal communication (machine monitor) system [DAFRMC] is indicated (if yes, diagnose that failure first.) Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 1 Defective mode selec- tor switch (Internal disconnec- tion or short circuit) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch ON.

Selector switch B52 (male) Position of selector switch Resistance Between (2) – (4) Manual Min. 1 Mz Between (3) – (4) Min. 1 Mz Between (2) – (4) Semiautomatic Min. 1 Mz Between (3) – (4) Max. 1 z Between (2) – (4) Automatic Max. 1 z Between (3) – (4) Max. 1 z 2 Disconnection in wir- ing harness (Disconnection in wir- ing harness or defec- tive contact in connector) aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch ON. Wiring harness between C02 (female) (2) – B52 (female) (2) Resis- tance Max. 1 z Wiring harness between C02 (female) (38) – B52 (female) (3) Resis- tance Max. 1 z Between B52 (female) (4) – chassis ground Resis- tance Max.

1 z 3 Grounding fault in wir- ing harness (Contact with ground- ing circuit) aPrepare with starting switch OFF (Turn clearance adjustment selector switch to manual position), then carry out troubleshooting without turn- ing starting switch ON. Wiring harness between C02 (female) (2) – B52 (female) (2) and chassis ground Resis- tance Min. 1 Mz Wiring harness between C02 (female) (38) – B52 (female) (3) and chassis ground Resis- tance Min. 1 Mz 4 Defective controller aPrepare with starting switch OFF, then carry out troubleshooting with- out turning starting switch ON. C02 (female) Position of selector switch Resistance Between (2) – chassis ground Manual Min.

1 Mz Between (38) – chassis ground Min. 1 Mz Between (2) – chassis ground Semiautomatic Min. 1 Mz Between (38) – chassis ground Max. 1 z Between (2) – chassis ground Automatic Max. 1 z Between (38) – chassis ground Max. 1 z