Kaiyi BR380JG-1E0 — E-18 TRAVEL CANNOT BE CONTROLLED BY RADIO CONTROL

SEN02095-00 40 Troubleshooting 38 BR380JG-1E0 Possible causes and standard value in normal state Cause Standard value in normal state/Remarks on troubleshooting 3 Disconnection in wiring harness (Disconnection in wir- ing harness or defec- tive contact in connector) Wiring harness between A33 (female) (7) – A45 (5) – D10 (female) (4) Resistance Max. 1 z Wiring harness between S23 (female) (2) – A02 (12) – A08A (2) – D10 (female) (5) (6) (7) (8) Resistance Max. 1 z Wiring harness between S23 (female) (1) – A02 (4) – C03 (female) (29) Resistance Max. 1 z 4 Defective solenoid aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON.

V20 (male), V21 (male), V22 (male), V23 (male) Resistance Between (1) – (2) 20 – 60 z Between (2) – chassis ground Min. 1 Mz 5 Defective diode aPrepare with starting switch OFF, then carry out troubleshooting without turning starting switch ON. Check the connector D10 according to "Testing procedure for diodes" in Testing and adjusting. 6 Defective travel lock EPC pressure switch (When the machine travels immediately after the switch is pressed but stops soon, travel lock EPC pressure switch may be defective.) Check with monitoring function of the machine monitor. (Code 25001:

Radio controller traveling signal) Start the engine and operate with the radio controller, ensuring the safety of surrounding area. (See Troubleshooting E-17, and operate the machine under the operable conditions.) Code 25001: Radio controller traveling signal) The ON display is normal when the radio controller is operating. When no fault is found in the troubleshooting 3 and 5 but a fault is found in this troubleshooting, travel lock EPC pressure switch may be defective 7 Defective transmitter and receiver If all the results of above checks 1 – 6 are normal, the transmitter or receiver is defective.