Kaiyi BR380JG-1E0 — S-2 ENGINE DOES NOT START

40 Troubleshooting SEN02307-00 *1:

Displayed failure codes [CA559] and [CA2249] BR380JG-1E0 9 c) Exhaust smoke comes but engine does not start (fuel is being injected) General causes why exhaust smoke comes out but engine does not start q Lack of rotating force due to defective electrical system q Insufficient supply of fuel q Insufficient intake of air q Improper selection of fuel Causes Clogged air cleaner element Worn dynamic valve system (Valve, rocker lever, etc.) Worn piston ring, cylinder liner Use of improper fuel Clogged air breather hole of fuel tank cap Leaking or clogged fuel system, entry of air Clogged fuel filter Stuck, seized supply pump plunger Clogged injector, defective spray Defective, deteriorated battery Defective coolant temperature sensor, wiring harness Defective intake air heater system Questions Check items Confirm recent repair history Degree of use of machine Operated for long period E E E Suddenly failed to start w w Q Non-specified fuel is being used Q Q Replacement of filters has not been carried out according to Operation and Mainte- nance Manual w w Engine oil must be added more frequently w When engine is preheated or when temperature is low, preheating monitor does not indicate normally w Dust indicator is red w Air breather hole of fuel tank cap is clogged Q Rust and water are found when fuel tank is drained w Fuel is leaking from fuel piping w When priming pump is operated, it makes no reaction or it is heavy w Q Starting motor cranks engine slowly w When engine is cranked, abnormal sound is generated around cylinder head w While engine is cranked with starting motor, If air bleeding plug of fuel filter is removed, fuel does not flow out Q w If spill hose from injector is disconnected, little fuel spills w Troubleshooting Inspect air cleaner directly q Inspect dynamic valve system directly q When compression pressure is measured, it is found to be low q When air is bled from fuel system, air comes out q Inspect fuel filter directly q Carry out troubleshooting according to “Rail Press (Very) Low Error (*1)” indicated by code q When specific gravity of electrolyte and voltage of battery are measured, they are low q Coolant temperature gauge does not indicate normally q When starting switch is turned to HEAT, intake air heater mount does not become warm q Remedy Clean Replace Replace Replace Clean Correct Clean Replace Replace Replace Replace Replace