40 Troubleshooting SEN02307-00 S-6 Engine lack output (or lacks power) 1 *1: Displayed failure codes [CA559] and [CA2249] *2: Displayed failure codes [CA122] and [CA123] BR380JG-1E0 13 General causes why engine lacks output q Insufficient intake of air q Insufficient supply of fuel q Defective spray condition of fuel q Improper selection of fuel q There is overheating o See “S-14 Coolant temperature becomes too high (Overheating)”.
q Controller is controlling in derate mode (limiting injection rate (output) because of an error in electrical system) Causes Clogged air cleaner element Air leakage from air intake piping Seized turbocharger, interference of turbocharger Defective contact of valve and valve seat Improper valve clearance Worn piston ring, cylinder liner Clogged air breather hole of fuel tank cap Leaking, clogged fuel piping Clogged fuel filter Stuck, seized supply pump plunger Clogged injector, defective spray (dirt in injector) Defective drive of injector (signal, solenoid) Defective installation of boost pressure sensor (air leakage) Defective boost pressure sensor, wiring harness Clogged spill piping Questions Check items Confirm recent repair history Degree of use of machine Operated for long period E E E E Power was lost Suddenly Q w Q Q Q Q Gradually Q Q Q Q Q Q Non-specified fuel is being used Q Q Q Replacement of filters has not been carried out according to Operation and Maintenance Manual w w Engine oil must be added more frequently Q Q Dust indicator is red w w Air breather hole of fuel tank cap is clogged w w Fuel is leaking from fuel piping w Output becomes insufficient after short stop of operation w Color of exhaust gas Black w w Blue under light load w When exhaust manifold is touched immediately after starting engine, temperature of some cylinders is low w w When engine is cranked, interference sound is generated around turbocharger w When engine is cranked, abnormal sound is generated around cylinder head w High idle speed is too high Q High idle speed under no load is normal, but speed suddenly drops when load is applied Q w Q Q Engine does not pick up smoothly and combustion is irregular w w Q Q w There is hunting from engine (rotation is irregular) Q Q Q Q Q Blow-by gas is excessive w w Troubleshooting Inspect air cleaner directly q Inspect air intake piping directly q When boost pressure is measured, it is found to be low q q q When compression pressure is measured, it is found to be low q q Inspect valve clearance directly q Inspect fuel piping q Inspect fuel filter, strainer directly q Inspect spill port check valve directly q Carry out troubleshooting according to “Rail Press (Very) Low Error (*1)” indicated by code q When a cylinder is cut out for reduced cylinder mode operation, engine speed does not change q q Inspect boost pressure sensor mount directly q Carry out troubleshooting according to “Chg Air Press Sensor High (Low) Error (*2)” indicated by code q Remedy Clean Correct Replace Replace Adjust Replace Clean Correct Replace Replace Replace Replace Correct Replace Replace