50 Disassembly and assembly SEN02738-00 Disassembly and assembly of lock cylinder 1 2) Using a pipe of a proper size, remove cle- vis (1) and washer (3). a Protect the pipe contact parts with cloths. a After clevis (1) is loosened, discon- nect it slowly so that it will not be seized. k Do not disassemble the parts other than those described in this section. Disassembly 1. Removal of clevis and flange 1) Remove the lock screw of clevis (1) and flange (2). q Screw size: M10 a After removing the lock screw, be sure to clean the screw hole with compressed air and apply anti-sei- zure compound to it. 2 Lock screw hole:
Anti-seizure compound (Molybdenum spray, etc.) 3) Fit the hook spanner to flange (2) and hit it with a hammer to loosen the flange, and then remove the flange. q Nominal diameter of hook spanner: 155/165 (mm) BR380JG-1E0 11