50 Disassembly and assembly SEN02738-00 25. Remove bolts (25) to remove the bearing from the frame. 28. Install cover (27) to the head pulley frame and secure it with bolts (28). 26. Remove the frame and replace it with a new one. Sub-assembly of head pulley frame 29. Apply jig (29) to measuring points f1 (E), f2 (F) and f3 (G) in the figure and adjust the frame width. a When adjusting the frame width, adjust the bearing side with a jack. 27. Connect the bearing and frame by bolts (26). 30. Apply jig (29) to measuring points h1 and h2 and check that contact of jig (29) and belt is even at points (J) and (K). a If contact is uneven, adjust the position.
a Dimension in the figure is as follows: h1 = h2 = 18 mm BR380JG-1E0 27