IP67 Charger — 4.2.3. Low current mode

Blue Smart IP67 Charger 4.2. Charge modes There are 3 integrated charge modes (Normal, High and Li-Ion), as well as an optional Recondition stage that can be included (except for Li-ion mode). The integrated charge modes combined with adaptive charge logic are well suited for most common battery types; such as flooded lead-acid, AGM, Gel and LiFePO4. The required charge mode can be selected via a Bluetooth enabled device (mobile phone or tablet) with the VictronConnect app; refer to the 'Setup > Setup using Bluetooth' section for more information.

If necessary, advanced configuration with user defined settings is also possible using a Bluetooth enabled device (mobile phone or tablet) with the VictronConnect app; refer to the 'Advanced configuration > Advanced settings' and 'Advanced configuration > Expert mode settings' sections for more information. All settings are stored and will not be lost when the charger is disconnected from mains power or the battery. 4.2.1. Charge voltage The charge voltage settings for each of the integrated charge modes are specified in the table below:

To ensure proper charging, battery longevity and safe operation it is important to select a charge mode appropriate for the battery type and capacity being charged; refer to the battery manufacturer’s recommendations. The Blue Smart IP67 Charger range feature temperature compensation, which will automatically optimise the nominal/configured charge voltage based on ambient temperature (except for Li-ion mode or if manually disabled); refer to the 'Operation > Temperature compensation’ section for more information. 4.2.2.

Recondition mode Recondition is an optional charge stage for lead acid batteries and not recommended for regular/cyclic use; use only if required, as unnecessary or overuse will reduce battery life due to excessive gassing. When recondition mode is enabled the recondition stage is included within the charge cycle (after the absorption stage is complete) and the battery voltage will be increased to an elevated level; refer to the 'Operation > Charge algorithm' section for more information. Recondition mode can be enabled and disabled via a Bluetooth enabled device (mobile phone or tablet) with the VictronConnect app; refer to the 'Setup > Setup using Bluetooth' section for more information.

4.2.3. Low current mode When low current mode is enabled the maximum charge current is limited to a significantly reduced level (varies per model); refer to the 'Technical specifications' section for more information. Low current mode is recommended when charging lower capacity batteries with a high current charger; charging at an excessive charge current can cause premature battery degradation and overheating. Typically the maximum charge current for lead acid based batteries should not exceed ~0.3C (more than 30% of the battery capacity in Ah) and the maximum charge current for LiFePO4 batteries should not exceed ~0.5C (more than 50% of the battery capacity in Ah).

Low current mode can be enabled and disabled via the VictronConnect app; refer to the 'Setup > Setup using VictronConnect' section for more information. Page 8 Operation Mode Absorption Float Storage Recondition 12V 24V 12V 24V 12V 24V 12V 24V Normal 14.4V 28.8V 13.8V 27.6V 13.2V 26.4V Disabled Normal + Recondition 14.4V 28.8V 13.8V 27.6V 13.2V 26.4V 16.2V 32.4V High 14.7V 29.4V 13.8V 27.6V 13.2V 26.4V Disabled High + Recondition 14.7V 29.4V 13.8V 27.6V 13.2V 26.4V 16.5V 33.0V Li-ion 14.2V 28.4V Disabled 13.5V 27.0V Disabled