IP67 Charger — 5.2.3. Start interrupt output

Blue Smart IP67 Charger 5.2.3. Start interrupt output The Blue Smart IP67 Charger 12/25(1+Si) and 24/12(1+Si) models are fitted with a start interrupt output, in addition to the main charge output. It is provided by the orange wire that exits the enclosure together with the DC output cable. The start interrupt output is active only when the charger is connected to mains, independently of the charge stage. It supplies a maximum of 0.5A, at a voltage up to 1V below the actual output voltage of the charger. This is commonly used on emergency vehicles such as ambulances and fire trucks. Page 17 Installation The output signals that the charger is connected to mains.

It is typically used to drive a relay, either to warn the driver or to interrupt the start circuit of the vehicle, so that the engine cannot be started while the vehicle is still plugged in. The relay coil, or any other device connected to this output, must not draw more than 0.5A. Start interrupt output