IP67 Charger — 6.1. Setup using VictronConnect

Blue Smart IP67 Charger 6. Setup 6.1. Setup using VictronConnect The charge mode and charge current limit most appropriate for the battery type and capacity can only be selected using a Bluetooth enabled device (mobile phone or tablet) with the VictronConnect app. For further information about the VictonConnect app refer to the VictronConnect manual . To setup using Bluetooth: 1. Download and install the VictronConnect app onto the Bluetooth enabled device (mobile phone or tablet). The VictronConnect app can be downloaded from the following locations: A. Android - Google Play Store B. iOS/Mac - Apple App Store C. Windows and other - Victron Energy website > Downloads > Software 2.

Enable Bluetooth on the Bluetooth enabled device (mobile phone or tablet) if not already enabled, but do not attempt to pair with the Blue Smart IP67 Charger . 3. Connect the Blue Smart IP67 Charger AC power cable to a mains power outlet; after a short delay the POWER LED will illuminate and the STATUS LED will begin to blink fast. 4. Open the VictronConnect app and locate the Blue Smart IP67 Charger in the Device list Local page, under Other devices.

In case the Blue Smart IP67 Charger does not automatically appear, ensure that the mobile phone or tablet has Bluetooth enabled and is within close range, then perform a manual scan for devices by selecting the Scan button (round orange button with circular arrow) in the bottom right corner. Page 20 Setup