IP67 Charger — 6.1. Setup using VictronConnect

Blue Smart IP67 Charger 8. Select the Settings icon (gear in the top right corner) to access the Settings page. 9. Select the most appropriate integrated charge mode (Normal, Normal + Recondition, High, High + Recondition or Li-ion) from the Charge preset menu. Ensure that recondition stage is only enabled when required, as unnecessary or overuse will reduce battery life. 10. If the maximum rated charge current is excessive, enable low current mode (charge current limited to a significantly reduced level - varies per model, refer to the 'Technical specifications' section for more information). To enable (or disable) low current mode select the required option from the Charge current menu.

11. Lock Mode Button - When enabled, the mode button is locked and cannot change the charger’s configuration. However, the following functions still work: Restart charge cycle to Bulk Reset Bluetooth When locked, pressing or holding the button will cause all LEDs to flash to indicate the lock is active. All settings are stored and will not be lost when the charger is disconnected from mains power or the battery. To ensure proper charging, battery longevity and safe operation it is important to select a charge mode appropriate for the battery type and capacity being charged; refer to the 'Operation > Charge modes' section and the battery manufacturers recommendations for more information.

Page 22 Setup