Blue Smart IP67 Charger 6.2.4. Re-enabling Bluetooth During this procedure: A. Bluetooth operation is re-enabled B. The Bluetooth PIN code is reset to 000000 (not the default PIN code stated on the label) C. Bluetooth pairing information is cleared Accordingly it is necessary to unpair all devices (mobile phones or tablets) previously paired with the Blue Smart IP67 Charger and establish a new Bluetooth pairing. If Bluetooth was disabled using option #1 ‘Enabled for 30 seconds’, Bluetooth communication can be re-enabled using a Bluetooth enabled device (mobile phone or tablet) with the VictronConnect app.
If Bluetooth was disabled using option #2 ‘Disabled’, this is irreversible and Bluetooth communication cannot be re-enabled. To re-enable Bluetooth: 1. Connect the Blue Smart IP67 Charger AC power cable to a mains power outlet; after a short delay the POWER LED will illuminate and the STATUS LED will begin to blink fast. 2.
Using a Bluetooth enabled device (mobile phone or tablet), open the VictronConnect app and locate the Blue Smart IP67 Charger in the Device list Local page, then connect to the device within the first 30 seconds after power-up while Bluetooth is temporarily enabled (the default PIN code is stated on a label located on the side of the charger, or try 000000 if there is no label). 3. Select the Settings icon (gear in the top right corner) to access the Settings page. 4. Select the Device options icon (three vertical dots in the top right corner) to access the Device options dropdown menu. 5. Select Product info from the dropdown menu to access the Product info page. Page 34 Setup