IP67 Charger — 6.3.2. Manual firmware update

Blue Smart IP67 Charger 6.3.2. Manual firmware update Updating firmware manually is typically not required but there are some rare circumstances when it may be necessary, such as: A. Updating to a new firmware version that has just been released and is available for download via the Victron Professional Portal , but not included in the VictronConnect app version currently available; alternatively wait for the next VictronConnect app version to be released B. Updating to an unreleased beta firmware version for testing purposes C. Updating to an unreleased special firmware version provided by Victron D.

Downgrading to an older firmware version, typically for troubleshooting/comparative purposes To update firmware manually: 1. Using a Bluetooth enabled device (mobile phone or tablet) with the VictronConnect app installed, access the required firmware file (.xup file extension) via a file browser, file hosting service/application, collaboration service/application, or email service/application and directly open the file (if prompted, select Open with VictronConnect ). 2.

After a short delay the VictronConnnect app will automatically open and then a pop-up dialog box will appear confirming that the firmware file has been successfully loaded into the Firmware library; if the VictronConnect app does not open and/or the pop-up dialog box does not appear try a different method to access the file. 3. Connect the Blue Smart IP67 Charger AC power cable to a mains power outlet; after a short delay the POWER LED will illuminate and the STATUS LED will begin to blink fast. 4.

Using the same Bluetooth enabled device (mobile phone or tablet), open the VictronConnect app (if not already open) and locate the Blue Smart IP67 Charger in the Device list Local page, then connect to the device (the default PIN code is stated on a label located on the back of the charger, or try 000000 if there is no label). Page 40 Setup