Greasing side stand Checking specified torque of threaded fasteners with torque wrench (Inspections II and III) Side stand (Inspections I, II, III and IV) – Place the motorcycle on the auxiliary stand, BMW No. 00 1 620 . • Check the security of the following threaded fas- teners: – Engine mounting bolts and nuts – Threaded fasteners of frame – Threaded fasteners of rear frame – Eccentric clamp – manifold fastener X Tightening torque: Engine to frame at rear................................. 50 Nm Cylinder head to frame ................................. 41 Nm Cylinder head to frame, locknut.................. 100 Nm Engine shell to engine ..................................
55 Nm Engine shell to engine at bottom with truss.. 55 Nm Engine shell to tube ..................................... 24 Nm Rear frame to main frame (clean thread + Loctite 2701)........................ 24 Nm Eccentric clamp, rear swinging arm Initial torque ................................................. 10 Nm Final torque .................................................. 21 Nm Exhaust manifold to cylinder head................ 20 Nm Silencer to exhaust manifold ........................ 55 Nm E460011 • Grease bearing bush (arrow) with a grease gun until fresh grease emerges at the lubricated fac- es. • If very dirty and stiff to move, remove the side stand and grease its pivots. Lubricant:
for bearing bushing .......... Staburags NBU 30 PTM 00.61