Bosch — 16 Troubleshooting

en Troubleshooting Fault Cause and troubleshooting Coffee tastes burnt. ▶ Set the coffee temperature lower. Coffee grounds are not compact and are too wet. The grinding level is not set optimally. ▶ Adjust the grinder to a coarser or finer setting. Beans are too oily. ▶ Use a different type of bean. Display shows "Please insert brewing unit.". Cover is wrongly inserted. 1. Check whether the brewing unit is inserted correctly and is securely locked. 2. Push the red lever up to the left. 3. Insert the brewing unit cover. Display shows "Please fill water tank." despite the fact that the water tank is full. Water tank is wrongly inserted. ▶ Insert the water tank correctly.

Float is stuck in the water tank. 1. Remove the water tank. 2. Clean the water tank thoroughly. New water filter was not rinsed as per instructions. 1. Rinse the water filter according to the instructions. 2. Place the water filter into operation. Air is in the water filter. 1. Immerse the water filter in water with the opening facing upwards until no more air bubbles escape. 2. Reinsert the filter. Water filter is old. ▶ Insert a new water filter. Limescale deposits in the water tank are blocking the system. 1. Clean the water tank thoroughly. 2. Start the descaling programme. Display shows "E61: Please clean brewing unit.". Brewing unit is soiled. ▶ Clean the brewing unit.

Mechanism of brewing unit is stiff. ▶ Clean the brewing unit. Display shows "Incor- rect voltage". There are problems with the power supply. ▶ Only operate the appliance at 220 - 240 V. Display shows "Re- start appliance". Appliance has a fault. 1. Set the mains switch to and wait 60 seconds. 2. Set the mains switch to ⁠. 68