Chapter 2: Installation Front Panel Audio Control When front panel headphones are plugged in, the back panel audio output is disabled. This is done through the FP Audio header (J12). If the front panel interface card is not connected to the front panel audio header, jumpers should be installed on the header (J12) pin pairs: 1-2, 5-6, and 9-10. If these jumpers are not installed, the back panel line out connector will be disabled and microphone input Pin 1 will be left floating, which can lead to excessive back panel microphone noise and cross talk. See the table below for pin definitions.
CD Header In addition to the front panel audio connector, a 4-pin CD header is located at CD1 on the motherboard. These headers allow you to use the onboard sound for audio CD playback. Con- nect an audio cable from your CD drive to the header that fits your cable's connector. Only one CD header can be used at any one time. See the tables at right for pin definitions. VGA Slot1 PCI 33MHz JWOL CTRL USB 8/9 USB6 USB7 Printer COM1 JWOR Floopy 1394_1 1394_2 JL1 IDE Fan4 2-21 FP Audio Pin Definitions Pin# Defin.
1 MIC_L 2 AUD_GND 3 MIC_R 4 FP-Audio-Detect 5 Line_2_R 6 Ground 7 FP-Jack-Detect 8 Key 9 Line_2_L 10 Ground CD1 Pin Definition Pin# Definition 1 Left Stereo Signal 2 Ground 3 Ground 4 Right Stereo Signal 2Mouse JPKB W/ CPU Fan Fan1 CPU HDMI SPDIF_Out DIMM1A DIMM1B USB/0/1USB2/3/4/5 Fan5 Intel LAN1 JPUSB1 G45 (C2SEA) G43 (C2SEE) AUDIO DIMM1 DIMM2 HD Slot7 PCI-E x1 C2SEA/C2SEE JPL1 Slot6 PCI-E Gen2 x16 SPI BIOS CLTaRnL A Slot5 PCI 33MHZ CMOS CLEAR Int IC FP Audio Slot4 PCI-E x4 on x16 B Slot3 PCI 33MHz Battery JPAC JI2C1 JI2C2 JD1 S I/O CD1 Slot2 PCI 33MHz SPKR1JPD1 JPI1 IDE A. Front Panel Audio B.
CD-In DIMM2A DIMM2B JPW1 DIMM3 DIMM4 Fan2 LE1Fan3 el JLED H10 JF1 JWD I-SATA0JOH I-SATA4 I-SATA1 I-SATA5 I-SATA2 USB 10/11 I-SATA3