C2SEA/C2SEE User's Manual 3-3 Frequently Asked Questions Question: What type of memory does my motherboard support? Answer: The C2SEA/C2SEE supports unbuffered, DDR3 1333/1066/800 MHz memory modules. See Section 2-4 for details on installing memory. Question: Why does Microsoft Windows XP (SP2) and Windows Vista show less memory than what is physically installed? Answer: Microsoft implemented a design change in Windows XP with Service Pack 2 (SP2) and Windows Vista. This change is specific to the Physical Ad- dress Extension (PAE) mode behavior which improves driver compatibility. For more information, please read the following article at Microsoft’s Knowledge Base website at:
http://support.microsoft.com/kb/888137. Question: How do I update my AMI BIOS? Answer: It is recommended that you do not upgrade your BIOS if you are not experiencing any problems with your system. Updated BIOS files are located on our web site at http://www.supermicro.com/support/bios/ . Please check our BIOS warning message and the information on how to update your BIOS on our web site. Select your motherboard model and download the BIOS (.rom) file to your computer. Also, check the current BIOS revision and make sure that it is newer than your BIOS before downloading. You may choose the zip file or the .exe file.
If you choose the zipped BIOS file, please unzip the BIOS file onto a bootable device or a USB pen/thumb drive. To flash the BIOS, run the batch file named "ami.bat" with the new BIOS .rom file from your bootable device or USB pen/thumb drive. Use the following format: F:\> ami xxxxxxxx.rom Notes: Be sure to type in a space after "ami". Always use the file named “ami. bat” to update the BIOS. When completed, your system will automatically reboot. If you choose the .exe file, please run the .exe file under Windows to create the BIOS flash floppy disk. Insert the floppy disk into the system you wish to flash the BIOS. Then, boot the system to the floppy disk.
The BIOS utility will automatically flash the BIOS without any prompts. Please note that this process may take a few minutes to complete. Do not be concerned if the screen is paused for a few minutes. : Do not shut down or reset the system while updating the BIOS to prevent possible system boot failure! When the BIOS flashing screen is completed, the system will reboot and will show “Press F1 or F2”. At this point, you will need to load the BIOS defaults. Press to go to the BIOS setup screen, and press to load the default settings. Next, press to save and exit. The system will then reboot. 3-4 ! Warning to prev