Super Micro Computer, Inc. C2SEA/C2SEE — Super Micro C2SEA/C2SEE User's Manual PDF Download

C2SEA/C2SEE User’s Manual function to reallocate the overlapped physical memory to a location above the total physical memory to resolve the memory overlapping situation. The options are Enabled and Disabled. PCI MMIO Allocation Use this feature to assign the address for PCI Memory-mapped IO (MMIO) allocation. The Default setting is 4 GB to 3200 MB . DRAM Frequency This feature allows the user to select the DRAM Frequency setting.

The options are Auto (Auto-detect) , 533 MHz, 667 MHz, 800 MHz, 1067 MHz and 1333 MHz Configure DRAM Timing by SPD Select Enable to allow the BIOS to read the SPD (Serial Presence Detect) chip which is built in the memory module in order to get the exact memory specifica- tions. The options are Enabled and Disabled. Memory Hole Use the feature to allocate memory resource reserved for use of PCI devices. If set to 15 MB~16MB, the reserved memory will be placed in the location around 15 MB~16 MB. The options are Disabled and 15 MB~ 16 MB. Initiate Graphics Adapter Use this feature to select the graphics controller to be used as the primary boot device.

The options are IGD, PCI/IGD, PCI/PEG, PEG/IGD, and PEG/PCI . See below for an explanation of the acronyms. For example, if PEG/PCI is selected, the system will look for a PCI-E graphics (PEG) adapter first, if none is found then it uses the PCI graphics (PCI) adapter to boot with. PEG - P CI- E G raphics adapter (optional add-on card) PCI - PCI graphics adapter (optional add-on card) IGD - I nternal G raphics D isplay (built-in) IGD Graphics Mode Select Use the feature to set the amount of system memory to be used by the Internal Graphics Devices. The options are Disabled, Enabled 32 MB , Enabled 64 MB, and Enabled 128 MB.

IGD GTT Graphics Memory Size This feature allows the user to select the IGD GTT Graphics Size. The Default setting is No VT Mode, 2 MB . 4-8