Super Micro Computer, Inc. C2SEA/C2SEE — Super Micro C2SEA/C2SEE User's Manual PDF Download

C2SEA/C2SEE User’s Manual Use this feature to set the system time-out value to allow the BIOS to detect the HDD devices installed in the system. The options are Disabled, 1 , 2, 3, 4, 5, 6, and 7 (seconds). Hard Disk Detect Time Out PCI/PnP Configuration This feature allows the user to set the PCI/PnP configurations for the following items: Clear NVRAM Select Yes to clear NVRAM during system boot. The options are No and Yes . Plug & Play OS Select Yes to allow the OS to configure Plug & Play devices. (This is not required for system boot if your system has an OS that supports Plug & Play.) Select No to allow the AMI BIOS to configure all devices in the system.

PCI Latency Timer This feature sets the latency Timer of each PCI device installed on a PCI bus. Select 64 to set the PCI latency to 64 PCI clock cycles. The options are 32, 64 , 96,128,160, 192, 224 and 248. Allocate IRQ to PCI VGA Select Yes to allow the system to give the VGA adapter card an interrupt address. The options are Yes and No. Palette Snooping Select Enabled to inform the onboard PCI devices that an ISA graphics device is installed in the system in order for the graphics card to function properly. The op- tions are Disabled and Enabled. PCI IDE BusMaster Select Enabled to allow the BIOS to use the PCI busmaster to read from and write to the onboard IDE drives.

The options are Disabled and Enabled . PCI Slot 1, 2, 4, 6, 7 Select Yes to enable OPROM for a PCI slot specified. The options are Yes (to en- able OPROM for the slot specified) and No. Load Onboard LAN Option ROM Select Enabled to load the onboard LAN Option ROM. The options are Enabled and Disabled . 4-14