Appendix A: AMIBIOS Error Beep Codes Appendix A BIOS Error Beep Codes During the POST (Power-On Self-Test) routines, which are performed each time the system is powered on, errors may occur. Non-fatal errors are those which, in most cases, allow the system to continue the boot-up process. The error messages normally appear on the screen. Fatal errors are those which will not allow the system to continue the boot-up procedure. If a fatal error occurs, you should consult with your system manufac- turer for possible repairs. These fatal errors are usually communicated through a series of audible beeps.
The numbers on the fatal error list, on the following page, correspond to the num- ber of beeps for the corresponding error. A-1 BIOS Error Beep Codes Beep Code Error Message Description 1 beep Refresh Circuits have been reset. (Ready to power up) 5 short beeps, 1 long beep Memory error No memory detected in the system 8 beeps Display memory read/write error Video adapter missing or with faulty memory 1 continuous beep (with the front panel OH LED on) System Overheat 1 continuous beep with the front panel OH LED on