C7C232-CB-ML User's Manual No Video 1. If the power is on but you have no video, remove all the add-on cards and cables. 2. Use the speaker to determine if any beep codes exist. Refer to Appendix A for details on beep codes. Note: If you are a system integrator, VAR or OEM, a POST diagnostics card is recom mended. For I/O port 80h codes, refer to Appendix B. System Boot Failure If the system does not display POST (Power-On-Self-Test) or does not respond after the power is turned on, check the following: 1. Check for any error beep from the motherboard speaker. If there is no error beep, try to turn on the system without DIMM modules installed.
If there is still no error beep, replace the motherboard. If there are error beeps, clear the CMOS settings by unplugging the power cord and contacting both pads on the CMOS Clear Jumper (JBT1). Refer to chapter 2. 2. Remove all components from the motherboard, especially the DIMM modules. Make sure that system power is on and that memory error beeps are activated. 3. Turn on the system with only one DIMM module installed. If the system boots, check for bad DIMM modules or slots by following the Memory Errors Troubleshooting procedure in this Chapter. Memory Errors 1. Make sure that the DIMM modules are properly and fully installed. 2. Confirm that you are using the correct memory.
Also, it is recommended that you use the same memory type and speed for all DIMMs in the system. See Section 2.4 for memory details. 3. Check for bad DIMM modules or slots by swapping modules between slots and noting the results. 4. Check the power supply voltage 115V/230V switch. 50