Chapter 2: Installation USB Wake-Up (JPUSB 1/2) Use jumper JPUSB1 to activate the "wake- up" function of the USB ports by pressing a key on a USB keyboard or clicking the USB mouse connected. This jumper is used together with a USB Wake-Up feature in the BIOS. Enable this jumper and the USB sup port in the BIOS to wake up your system via USB devices. USB Wake-Up Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled (Default) Note : Use JPUSB1 for the USB ports on the back panel, and JPUSB2 for the front panel USB headers.
Over-Clocking Buttons (OC1,OC2, OC3) Over-Clocking Buttons Switch Settings Press these buttons to activate the over- clocking feature of the motherboard. These buttons will allow the CPU to run above its rated speed. This is an advanced feature and should only be used by experienced users. Also, refer to the CMOS Reset/Clear features on page 2-20 for related information. Switch Setting Definition OC1 On 15% Over-Clock OC2 On 20-25% Over-Clock OC3 On User Defined (BIOS) A B 2-35