Chapter 4: AMI BIOS If the item above - SATA Mode Select is set to IDE, the following items are displayed: Serial ATA Port 0~ Port 5 This item displays the information detected on the installed SATA drives on the particular SATA port. Model number of drive and capacity Software Preserve Support If the item above - SATA Mode Select is set to RAID, the following items are displayed: Serial ATA Port 0~ Port 5 This item displays the information detected on the installed SATA drives on the particular SATA port. Model number of drive and capacity Software Preserve Support Port 0 ~ Port 5 Hot Plug This feature designates this port for hot plugging.
Set this item to Enabled for hot-plugging support, which will allow the user to replace a SATA drive without shutting down the system. The options are Enabled and Disabled. Port 0 ~ Port 1 SATA Device Type This feature configures the selected SATA port to support either a solid state drive or hard disk drive. Set this item to Enabled to enable hot-plugging. The options are Hard Disk Drive and Solid Sate Drive. Port 0 ~ Port 5 Spin Up Device On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE SET initialization sequence to the device. The options are Enabled and Disabled .
PCIe/PCI/PnP Configuration This feature allows the user to set the PCI/PnP configurations for the following items: Above 4G Decoding Select Enabled for 64-bit devices to be decoded above the 4GB address space If 64bit PCI decoding is supported by the system. The options are Disabled and Enabled. 4-19