Remote Control 1 Infrared Remote Emitter Sends a signal to the infrared remote receiver on the main unit. 2 POWER button (P27, 45) Turns the projector on or off. 5 3 MENU button (P50) Displays a menu. 2 3 BEFORE USE 4 6 4 COMPUTER-1 button (P28, 46) Selects the image input from the DVI-I/RGB IN-1 terminal. Pressing this button continuously allows you to select an input signal (DIGITAL RGB or ANALOG RGB-1). 7 8 9 5 COMPUTER-2 button (P28, 46) Selects the image input from the RGB IN-2/ COMPONENT IN/RGB OUT terminal. Pressing this button continuously allows you to select an input signal (ANALOG RGB or COMPONENT).
10 11 12 6 VIDEO/S button (P46) Select the image input from the VIDEO IN terminal or S-VIDEO terminal. Pressing this button continuously allows you to select input signals (VIDEO or S-VIDEO). 14 13 15 17 Remote Control Operating Range Point the remote control to the infrared remote receiver whenever pressing any button. The maxi- mum operating range is about 5 m (16.4' ) and 30 o in front of the infrared remote receiver. 16 18 19 21 20 5m ( 16.4 ' ) 30 o 30 o Within 5 m (16.4' ) and 30 o in front of infrared remote receiver The remote control may be inoperative in the following cases: When there is an obstacle between the remote control and main unit.
When the infrared remote receiver on the main unit is exposed to direct sunlight or strong light of lighting equipment. All operations of the projector can be controlled with the remote control. The remote control uses infrared light. When you use two projectors at the same time, you can change the channel settings to prevent the two remote controls from interfering with each other. (P72) 16 1