4.7.1 Services Overview Oil Reset This function allows you to reset the oil service lamp for the engine oil life system, which calculates an optimal oil life change interval depending on the vehicle driving conditions and weather events. Oil reset is required every time the engine oil is changed. Throttle Adaptation If the ECU is disconnected accidentally, or if the throttle is replaced or cleaned, then the throttle actuators need to be initialized via the Throttle Adaptation function. This resets the ECU's data to its initial state so that the throttle can accurately regulate the air intake. EPB Reset This function helps you replace and reset the brake pads.
It needs to be performed in the following cases: • After the brake pads and brake pad wear sensor are replaced; • When the brake pad warning light is on; • After a short circuit in the brake pad sensor is fixed; • After the servo motor is replaced. BMS Reset After the car battery is replaced, the car battery control unit needs to be reset. This will clear fault information (such as low battery level) so that the control unit can match the relevant information of the newly replaced battery. TPMS Reset After the tire has been reinflated or replaced, the tire pressure information needs to be reset via the tire pressure reset function to resolve the tire pressure fault code.
DPF Regeneration This function is mainly used for the regeneration of diesel particulate filters. To keep the filters performing well it removes particles by means of combustion and oxidation. 27