Mode and Character-Set Selection ESC "7" ESC "6" ESC "@" Select CG Table 1 Select CG Table 2 Reset code. Special Printer Features ESC " ESC "U" CHR$(0) Turns one-line unidirectional mode ON. Turns continuous unidirectional mode OFF. Turns continuous unidirectional mode ON. ESC "U" CHR$(1) Line Spacing ESC "O" ESC "1" ESC "2" Sets line spacing to 1I8-inch. Sets line spacing to 7 /72-inch. Executes the line spacing specified by ESC "A." If no ESC "!\' command has been given, line feeding returns to 1I6-inch. Sets line spacing to n/72-inch (effective after sending ESC "2"). Sets line spacing to n I 216-inch. Produces an immediate one-time line feed of n/ 216-inch without a carriage return.
ESC 'W' n ESC "3" n ESC "]" n Forms Control ASCII 12 ESC "8" ESC "9" ESC "C"O n ESC "C" n ESC "N" n ESC "O" Activates a form-feed. Turns the paper-out sensor OFF. Turns the paper-out sensor ON. Sets the form length in inches. Sets the form length in lines. Turns variable skip-over-perforation ON. Turns skip-over-perforation OFF. B-9