Table 1-1. DIP switch functions (Commodore mode). NOTE: Printer is set for Commodore mode at the factory. If DIP switch 1-1 is ON, the MPS 1000 is in its IBM mode. Table 1-2 applies to IBM mode. DIP switches are read at power-on reset. Table 1-2. DIP switch functions (IBM mode) ·with DIP Switch 1-1 in the ON state (IBM mode) and DIP Switch 1-3 in the OFF state (Centronics Parallel interface), DIP Switch 1-2 is CG Select rather than Device Select. Note : Default is Table 1 if Commodore Serial Bus is selected with IBM 5152+ Mode). DIP switches are read at power-on reset.
23 SW Function ON OFF 1· 1 Print Mode Selection IBM Commodore OFF 1-2 Device Select 5 4 OFF 1·3 Buzzer Mute Beep OFF 1-4 Controls Cut Sheet Feeder Valid Invalid OFF 1-5 NLQ/DRAFT Selection NLQ DRAFT OFF 1-6 Page Length 12" 11 " OFF 1-7 Paper End Detector Inactive Active OFF 1-8 Uni-Directional Printing Valid Invalid OFF SW Function ON OFF Factory Setting 1-1 Print Mode Selection 5152+ Commodore OFF 1·2 Character Graphic Select Table 2 Table1 OFF 1-3 Interface Serial Parallel OFF 1-4 Controls Cut Sheet Feeder Valid Invalid OFF 1-5 NLQ/DRAFT Selection NLQ DRAFT OFF 1-6 Page Length 12" 11" OFF 1-7 Paper End Detector Inactive Active OFF 1-8 Auto LF with CR Valid Invalid OFF