Commodore MPS 1000 — Commodore MPS 1000 Dot Matrix Printer User's Manual PDF

To print figures taller than eight dots, the print head makes more than one pass. It prints one line, then advances the paper and prints another, just as it does with text. To keep the print head from leaving gaps between graphics lines as it does between text lines, the line spac- ing must be adjusted to eliminate space between lines. When the line spacing is properly adjusted, the MPS 1000 prints finely detailed graph- ics images that give no indication that they are made up of separate lines, each no more than 1I8 of an inch wide.

To insure the proper alignment of dots in figures that use more than one pass of the print head, the MPS 1000 abandons the bidirectional printing it uses for draft text. Instead it prints graphics from left to right only. Each pass of the print head contains one piece of the total pattern, which can be as tall or short and as wide or narrow as you desire. You don't have to fill the whole page or even an entire line with your graph- ics figures. In fact, you can use as little or as much space as you like for a figure and put it anywhere on the page. IBM Dot Graphiei Mode The graphics mode command is different from the other commands covered so far in this manual.

For most of the other MPS 1000 modes, such as condensed and emphasized, one ESCape code turns the mode on and another turns it off. For graphics, the command is more compli- cated because the code that turns on a graphics mode also specifies how many columns it will use. The MPS 1000 has several different graphics densities, but we'll keep things simple by using only one in the first exercises. The code for entering single-density graphics mode is ESCape "K" nl n2 . In Com- modore BASIC the comman4 is given in this format: PRINT#4, CHR$(27) "K" CHR$(Nl) CHR$(N2) ; In Microsoft BASIC, the command is given in this format:

LPRINT CHR$(27)"K"CHR$(Nl)CHR$(N2); ESCape "K" specifies single-density graphics, and the next two num- bers (nl and n2) specify the number of columns reserved for graphics. The graphics command requires more than one number to specify how many columns to reserve because as many as 1,920 columns are possible in graphics printing. Since the MPS 1000 uses eight-digit 83