Design Your Own Graphics In this section we take you through the development of a graphics program. The example is not especially complicated, but it includes the same steps you would use for a more complex figure so that you have the basis for designing graphics on your MPS 1000. You will plan your figure with dots on graph paper, but before begin- ning to place the dots, you should decide which graphics density you want. Figure 7-3 shows the difference between the three most-used graphics modes so you can choose the one you want. Single High-speed Low-speed Double Double Figure 7-3.
Designing in different densities In this figure you can see the main rules for graphics design in the three densities. In single density, no dots can be placed on vertical lines. In high-speed double density, dots can be placed on vertical lines, but no dots can overlap. In low-speed double density, dots can be placed on vertical lines and they can overlap. 90 • - - • • • • - - • • •r • • • • •