4. Configure security protocol parameters (for example, RADIUS or TACACS+). 5. Use access control list AV pairs on the security server that the user can connect to the local host only by establishing a Telnet connection. 6. Configure the access-profile command as an autocommand. If you configure the autocommand, remote users will not have to manually enter the access-profile command to access authorized rights associated with their personal user profile. If the access-profile command is configured as an autocommand, users will still have to Telnet to the local host and log in to complete double authentication.
Note Follow these rules when creating the user-specific authorization statements (These rules relate to the default behavior of the access-profile command): • Use valid AV pairs when configuring access control list AV pairs on the security server. • If you want remote users to use the interface’s existing authorization (that which existed prior to the second stage authentication/authorization), but you want them to have different access control lists (ACLs), you should specify only ACL AV pairs in the user-specific authorization definition. This might be desirable if you set up a default authorization profile to apply to the remote host, but want to apply specific ACLs to specific users.
• When these user-specific authorization statements are later applied to the interface, they can either be added to the existing interface configuration, or replace the existing interface configuration--depending on which form of the access-profile command is used to authorize the user. You should understand how the access-profile command works before configuring the authorization statements. • If you will be using ISDN or Multilink PPP, you must also configure virtual templates at the local host. Configuring Automated Double Authentication To configure automated double authentication, perform the following task:
Procedure Configuring Authentication Configuring Automated Double Authentication Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password, if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 ip trigger-authentication [timeout seconds] [port number] Example: Enables automation of double authentication. Configuring Authentication 28