cisco — Configuring BGP Filtering with Route Maps

Configuring BGP Filtering with Route Maps To configure BGP filtering with route maps, perform the following procedure: Procedure Configuring BGP Configuring BGP Filtering with Route Maps Command or Action Purpose • ibgp number: The number of iBGP paths to be added to the IP routing table. Note The maximum-paths ibgp number command is supported from Cisco IOS XE Cupertino 17.9.6 and all subsequent Cisco IOS XE Cupertino 17.9.x releases, and from Cisco IOS XE 17.15.1 and all subsequent releases. Step 14 end Example: Device(config-router)# end Returns to privileged EXEC mode. Step 15 show ip bgp Example:

Device# show ip bgp Verifies the reset by checking information about the routing table and about BGP neighbors. Step 16 show ip bgp neighbors Example: Device# show ip bgp neighbors Verifies the reset by checking information about the routing table and about BGP neighbors. Step 17 copy running-config startup-config Example: Device# copy running-config startup-config (Optional) Saves your entries in the configuration file. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Configuring BGP 21