Configuring BGP Configuring BGP Route Map Next-hop Self Command or Action Purpose Step 10 match source-protocol source-protocol Example: Device(config-route-map)# match source-protocol connected Matches Enhanced Interior Gateway Routing Protocol (EIGRP) external routes based on a source protocol. Step 11 exit Example: Device(config-route-map)# exit Exits route-map configuration mode and enters global configuration mode. Step 12 router bgp autonomous-system-number Example: Device(config)# router bgp 45000 Enters router configuration mode and creates a BGP routing process. Step 13 neighbor {ip-address | ipv6-address | peer-group-name} remote-as autonomous-system-number Example:
Device(config-router)# neighbor 172.16.232.50 remote-as 65001 Adds an entry to the BGP or multiprotocol BGP neighbor table. Step 14 address-family vpnv4 Example: Device(config-router)# address-family vpnv4 Specifies the VPNv4 address family and enters address family configuration mode. Step 15 neighbor {ip-address | ipv6-address | peer-group-name} activate Example: Device(config-router-af)# neighbor 172.16.232.50 activate Enables the exchange of information with a Border Gateway Protocol (BGP) neighbor. Step 16 neighbor {ip-address | ipv6-address | peer-group-name} next-hop unchanged allpaths Example:
Device(config-router-af)# neighbor 172.16.232.50 next-hop unchanged allpaths Enables an external EBGP peer that is configured as multihop to propagate the next hop unchanged. Step 17 neighbor {ip-address | ipv6-address | peer-group-name} route-map map-name out Applies a route map to an outgoing route. Configuring BGP 52