cisco — Configuring a Single-Hop Template

Creating and Configuring BFD Templates You can configure a single-hop template to specify a set of BFD interval values. BFD interval values specified as part of the BFD template are not specific to a single interface. Configuring BFD-template will disable echo mode. Note Configuring a Single-Hop Template Perform this task to create a BFD single-hop template and configure BFD interval timers. Procedure Configuring Bidirectional Forwarding Detection Creating and Configuring BFD Templates Command or Action Purpose Device(config)#no bfd echo Step 4 end Example: Device(config)#end Exits global configuration mode and returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example:

Device>enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device#configure terminal Enters global configuration mode. Step 3 bfd-template single-hop template-name Example: Device(config)#bfd-template single-hop bfdtemplate1 Creates a single-hop BFD template and enters BFD configuration mode. Step 4 interval min-tx milliseconds min-rx milliseconds multiplier multiplier-value Example: Device(bfd-config)#interval min-tx 120 min-rx 100 multiplier 3 Configures the transmit and receive intervals between BFD packets, and specifies the number of consecutive BFD control packets that must be missed before BFD declares that a peer is unavailable.

Configuring Bidirectional Forwarding Detection 21