Configuring Link Aggregation Control Protocol Port-Channel Standalone Disable To disable the standalone EtherChannel member port state on a port channel, perform this task on the port channel interface: Procedure Configuring Link Aggregation Control Protocol Standalone Mode on EtherChannel To configure LACP Standalone or Independent mode on an EtherChannel, perform the following procedure: Configuring EtherChannels Configuring Link Aggregation Control Protocol Port-Channel Standalone Disable Command or Action Purpose Step 5 end Example: Device(config-if)# end Returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode.
Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 interface port-channel channel-group Example: Device(config)# interface port-channel channel-group Selects a port channel interface to configure. Step 4 port-channel standalone-disable Example: Device(config-if)# port-channel standalone-disable Disables the standalone mode on the port-channel interface. Step 5 end Example: Device(config-if)# end Exits configuration mode. Step 6 show etherchannel Example: Device# show etherchannel channel-group port-channel Device# show etherchannel channel-group detail Verifies the configuration. Configuring EtherChannels 22