Configuring Auto-LAG Globally To configure Auto-LAG globally, perform this procedure: Procedure Configuring Auto-LAG on a Port Interface To configure Auto-LAG on a port interface, perform this procedure: Configuring EtherChannels Configuring Auto-LAG Globally Command or Action Purpose Step 6 show lacp internal Example: Device# show lacp internal Device# show lacp counters Verifies your configuration. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 [no] port-channel auto Example:
Device(config)# port-channel auto Enables the auto-LAG feature on a switch globally. Use the no form of this command to disable the auto-LAG feature on the switch globally. Note By default, the auto-LAG feature is enabled on the port. Step 4 end Example: Device(config)# end Returns to privileged EXEC mode. Step 5 show etherchannel auto Example: Device# show etherchannel auto Displays that EtherChannel is created automatically. Configuring EtherChannels 28