Pkts: 0/0/0 Rate: 0 pps Tunnel1 Flags: F Pkts: 0/0/1 Rate: 0 pps Leaf-02# Return to Verifying the Layer 2 VNI with Back-to-Back Multicast Replication, on page 17 . Example: Configuring Layer 2 VNI with Back to Back Ingress Replication This example shows how to configure and verify a Layer 2 VNI with back-to-back ingress replication using the following topology: Figure 3: EVPN VXLAN Network with a Layer 2 VNI with Ingress Replication The topology shows an EVPN VXLAN network with two VTEPs (VTEP 1 and VTEP 2) and no spine switches. Ingress replication is performed between the VTEPs to forward BUM traffic in the network.
The following table provides sample configurations for the devices in this topology: Note In a two-VTEP topology, a spine switch is not mandatory. For information about configuration of spine switches in an EVPN VXLAN network, see Configuring Spine Switches in a BGP EVPN VXLAN Fabric module. Configuring EVPN VXLAN Layer 2 Overlay Network Example: Configuring Layer 2 VNI with Back to Back Ingress Replication Configuring EVPN VXLAN Layer 2 Overlay Network 23