cisco — Example: Configuring Layer 2 VNI with Spine Multicast Replication

SW Forwarding: 1/0/96/0, Other: 0/0/0 HW Forwarding: 2/0/168/0, Other: 0/0/0 GigabitEthernet1/0/2 Flags: A Tunnel0, VXLAN Decap Flags: F NS Pkts: 0/0/1 Rate: 0 pps Leaf-01# Return to Verifying the Layer 2 VNI with Spine Multicast Replication, on page 33 . Outputs to Verify the Configuration on VTEP 2 The following example shows the output for the show nve peers command on VTEP 2: Leaf-02# show nve peers Interface VNI Type Peer-IP RMAC/Num_RTs eVNI state flags UP time nve1 10101 L2CP 172.16.254.3 2 10101 UP N/A 00:01:39 Leaf-02# The following example shows the output for the show ip route command on VTEP 2: Leaf-02# show ip route Codes:

L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, m - OMP n - NAT, Ni - NAT inside, No - NAT outside, Nd - NAT DIA i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2 ia - IS-IS inter area, * - candidate default, U - per-user static route H - NHRP, G - NHRP registered, g - NHRP registration summary o - ODR, P - periodic downloaded static route, l - LISP a - application route + - replicated route, % - next hop override, p - overrides from PfR & - replicated local route overrides by connected Gateway of last resort is not set 172.16.0.0/16 is variably subnetted, 15 subnets, 2 masks O 172.16.13.0/24 [110/2] via 172.16.14.1, 01:44:23, GigabitEthernet1/0/1 C 172.16.14.0/24 is directly connected, GigabitEthernet1/0/1 L 172.16.14.4/32 is directly connected, GigabitEthernet1/0/1 O 172.16.23.0/24 [110/2] via 172.16.24.2, 01:44:23, GigabitEthernet1/0/2 C 172.16.24.0/24 is directly connected, GigabitEthernet1/0/2 L 172.16.24.4/32 is directly connected, GigabitEthernet1/0/2 O 172.16.254.1/32 [110/2] via 172.16.14.1, 00:10:18, GigabitEthernet1/0/1 O 172.16.254.2/32 [110/2] via 172.16.24.2, 00:09:02, GigabitEthernet1/0/2 O 172.16.254.3/32 [110/3] via 172.16.24.2, 01:44:20, GigabitEthernet1/0/2 [110/3] via 172.16.14.1, 01:44:15, GigabitEthernet1/0/1 C 172.16.254.4/32 is directly connected, Loopback1 O 172.16.255.1/32 [110/2] via 172.16.14.1, 01:44:23, GigabitEthernet1/0/1 O 172.16.255.2/32 [110/2] via 172.16.24.2, 01:44:23, GigabitEthernet1/0/2 O 172.16.255.3/32 [110/3] via 172.16.24.2, 01:44:20, GigabitEthernet1/0/2 [110/3] via 172.16.14.1, 01:44:15, GigabitEthernet1/0/1 Configuring EVPN VXLAN Layer 2 Overlay Network Example:

Configuring Layer 2 VNI with Spine Multicast Replication Configuring EVPN VXLAN Layer 2 Overlay Network 37