• Configure Layer 2 VPN EVPN on the VTEPs. • Configure an EVPN instance in the VLAN on the VTEPs. • Configure the access-facing interface in the VLAN on the VTEPs. • Configure the loopback interface on the VTEPs. • Configure the network virtualization endpoint (NVE) interface on the VTEPs. • Configure BGP with EVPN address family on the VTEPs. • Configure underlay multicast, if the specified replication type is static. For more information, see IP Multicast Routing Configuration Guide . Configuring Layer 2 VPN EVPN on a VTEP To configure the Layer 2 VPN EVPN parameters on a VTEP, perform the following steps:
Procedure Configuring EVPN VXLAN Layer 2 Overlay Network Configuring Layer 2 VPN EVPN on a VTEP Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password, if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 l2vpn evpn Example: Device(config)# l2vpn evpn Enters EVPN configuration mode. Step 4 replication-type {ingress | static} Example: Device(config-evpn)# replication-type static Configures the Layer 2 VPN EVPN replication type. Note Configure the Layer 2 VPN EVPN replication type as static, if multicast is enabled in the underlay network for EVPN BUM traffic.
When the Layer 2 VPN EVPN replication type is configured as static, the IMET route is not advertised and forwarding of BUM traffic relies on underlay multicast being configured on each VTEP. Configuring EVPN VXLAN Layer 2 Overlay Network 5