cisco Identity Based Networking Services (IBNS) — Configuring a Parameter Map for Web-Based Authentication

Example: Port Authentication interface GigabitEthernet 1/0/2 access-session host-mode single-host access-session closed access-session port-control auto access-session control-direction in Configuring a Parameter Map for Web-Based Authentication A parameter map allows you to modify parameters that control the behavior of actions configured under a control policy. A parameter map for web-based authentication sets parameters that can be applied to subscriber sessions during authentication. If you do not create a parameter map, the policy uses default parameters. Perform the following steps to define either a global or named parameter map for web-based authentication.

The configuration commands available in the global parameter map differ from the commands available in a named parameter map. Note Procedure Configuring Identity Control Policies Configuring a Parameter Map for Web-Based Authentication Command or Action Purpose Example: Device(config-if)# access-session closed • The port is set to open access by default. Step 7 access-session control-direction {both | in} Example: Device(config-if)# access-session control-direction in Sets the direction of authentication control on a port. • The default value is both. Step 8 end Example: Device(config-if)# end Exits interface configuration mode and returns to privileged EXEC mode.

Step 9 show access-session interface interface-type interface-number [details] Example: Device# show access-session interface gigabitethernet 1/0/2 details Displays information about subscriber sessions that match the specified client interface. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. • Enter your password if prompted. Configuring Identity Control Policies 14