cisco Identity Based Networking Services (IBNS) — Example: Configuring Control Policy for Concurrent Authentication Methods

Example: Parameter Map for Web-Based Authentication parameter-map type webauth PMAP_2 type webconsent timeout init-state sec 60 max-http-conns 5 type consent consent email custom-page login device flash:webauth_login.html custom-page success device flash:webauth_success.html custom-page failure device flash:webauth_fail.html custom-page login expired device flash:webauth_expire.html What to do next Apply the parameter map to sessions by specifying it in the authenticate using command when configuring a Control Policy. See the Configuring a Control Policy, on page 8 section. Configuration Examples for Cisco Identity-Based Control Policies Example:

Configuring Control Policy for Concurrent Authentication Methods The following example shows a control policy that is configured to allow concurrent authentication. All three methods (dot1x, MAB, and web authentication) are run simultaneously when a session is started. The dot1x method is set to the highest priority and web authentication has the lowest priority, which means that if multiple methods succeed, the highest priority method is honored. If authentication fails, the session manager checks whether all methods have failed, and if so, it sets the restart timer to 60 seconds, after which it attempts to start all three methods again.

On authentication success, the session manager terminates any lower priority methods; for dot1x, this is MAB and webauth; for MAB it is webauth. Lastly, if session manager detects a dot1x client (agent-found) it triggers only dot1x to run. The class map named ALL-FAILED checks that all three methods have run to completion (result type is none until then) and that none of them was successful. In other words, all three methods have completed and failed. When configuring a control policy for concurrent authentication, you must include a policy rule that explicitly terminates one method after another method of a higher priority succeeds.

Note class-map type control subscriber match-all ALL_FAILED no-match result-type method dot1x none no-match result-type method dot1x success no-match result-type method mab none no-match result-type method mab success no-match result-type method webauth none Configuring Identity Control Policies Configuration Examples for Cisco Identity-Based Control Policies Command or Action Purpose Device# show ip admission status custom-pages Configuring Identity Control Policies 17