cisco Identity Based Networking Services (IBNS) — Example: Configuring Parameter Maps

20 terminate webauth 30 authenticate using dot1x priority 10 The following example shows a control policy that is configured to allow sequential authentication methods using 802.1X and MAB. If authentication fails, a service template for VLAN is activated. service-template VLAN210 vlan 210 ! class-map type control subscriber match-all DOT1X_FAILED match method dot1x match result-type method dot1x authoritative ! class-map type control subscriber match-all DOT1X_NO_RESP match method dot1x match result-type method dot1x agent-not-found ! class-map type control subscriber match-all MAB_FAILED match method mab match result-type method mab authoritative !

policy-map type control subscriber POLICY_Gi3/0/14 event session-started match-all 10 class always do-until-failure 10 authenticate using dot1x retries 2 retry-time 0 priority 10 event authentication-failure match-first 10 class DOT1X_NO_RESP do-until-failure 10 terminate dot1x 20 authenticate using mab priority 20 20 class MAB_FAILED do-until-failure 10 terminate mab 20 activate service-template VLAN210 30 authorize 30 class DOT1X_FAILED do-until-failure 10 terminate dot1x 20 authenticate using mab priority 20 40 class always do-until-failure 10 terminate dot1x 20 terminate mab 30 authentication-restart 60 event agent-found match-all 10 class always do-until-failure 10 terminate mab 20 authenticate using dot1x retries 2 retry-time 0 priority 10 Example:

Configuring Parameter Maps Global Parameter Map The following example shows the configuration of a global parameter map: parameter-map type webauth global timeout init-state sec 15 watch-list enabled virtual-ip ipv6 FE80::1 redirect on-failure http://10.10.3.34/~sample/failure.html max-http-conns 100 watch-list dynamic-expiry-timeout 5000 banner file flash:webauth_banner.html Configuring Identity Control Policies Example: Configuring Parameter Maps Configuring Identity Control Policies 19