Configuring the Source Interface and DSCP Marking on RADIUS Server Group Follow these steps to configure the source interface and DSCP marking for authentication and accounting on radius server groups: Procedure Configuring RADIUS Configuring the Source Interface and DSCP Marking on RADIUS Server Group Command or Action Purpose Step 4 address { ipv4 | ipv6 } ip address [auth-port auth port number acct-port _ _ acct port number] _ _ Example: Device(config-radius-server)# address ipv4 10.1.1.1 auth-port 1645 acct-port 1646 (Optional) Specifies the IP address of the RADIUS server. • auth-port configures the port value for radius authentication server. The default value is 1812.
• acct-port configures the port value for radius accounting server. The default value is 1813. Step 5 dscp {acct dscp acct value|auth _ _ dscp auth value} _ _ Example: Device(config-radius-server)# dscp auth 10 acct 20 Configures DSCP marking for authentication and accounting on the radius server. • acct configures radius DSCP marking value for accounting. The valid range is from 1 to 63. The default value is 0. • auth configures radius DSCP marking value for authentication. The valid range is from 1 to 63. The default value is 0. Step 6 key string Example:
Device(config-radius-server)# key rad123 Specifies the shared secret text string used between the device and the vendor-proprietary RADIUS server. The device and the RADIUS server use this text string to encrypt passwords and exchange responses. Step 7 end Example: Device(config-radius-server)# end Exits RADIUS server mode and enters privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Configuring RADIUS 35