Atari Games Cops — Cops TM-398 1st Printing COLOR COVERS_Page_2.jpg

Cops OPERATOR’S MANUAL Display Test Pressing %& CHAPTER 2 — SELF-TEST MODES NOTE Switch C produces *s and Os flashing alter- The Steering Test will not work correctly if nately in each character of the alphanumeric display. the DAC Set Test has not been successtful- Make sure that each segment lights up. Press Switch A to exit this test. ly completed. Shake Motor Test Switch Test Press Switch C to start the shake motor. Press Switch C again to stop the shake motor. Press Switch A to exit this test. This test checks the coin and gas pedal switches. To enter this test mode, press Switch C. Each switch pressed will then be identified on the display.

Press and hold the Service Switch for 3 seconds to exit this test. CAUTION Do not test the shake motor for more than five minutes continuously or you may dam- Setup Menu age it. Adjust Center Audio Test Pressing Switch C produces a still picture of a gun target on the monitor. Press Switch A to move the picture left, or Switch B to move the picture right. You should NOTE The audio boards, the CD player, and the CD-ROM disc must be installed and connected to the game to perform this test. position the target in the center of the screen. Press Switch C to lock in the new settings. Press Switch A to exit this test.

Set Difficulty Repeatedly pressing Switch A during this test causes sounds to be produced from ail the loudspeakers in Pressing Switch C shows the current game difficulty setting on the display. Press Switch A to step through the difficulty settings — easy, medium, and difficult. the following order: CHAN A Tone from the top left speaker; the volume will go up and down. CHAN B Static noise from the top right speaker CHAN C Siren from the lower left speaker CHAN D Music from the lower right speaker CHAN LEFT Tire sounds from the lower left speaker CHAN RIGHT Tire sounds from the lower right Press Switch C to lock in the desired setting. Press Switch A to exit this test.

Set Demo BEEP tract-mode audio is played. Pressing Switch A toggles through the settings 1/1 (sound on continuously), 1/2, 1/4, and 1/8 (sound on every 8th attract sequence). Press Switch C to lock in the new setting. Press Switch A to exit this test. Beeps from the center speaker Press Switch C to exit this test. Adjust Volume DAC/Steer Test Pressing Switch C produces a two-digit code on the display. Allow the steering wheel to center itself, and adjust the set steering multi-turn 5K potentiometer on Pressing Switch C shows the current volume setting on the display. Press Switch B to increase, or Switch A to ~ the Logic Control board until the display reads 80.

; (This pot is located next to the U47 chip.) The two-digit code should change from 00 to FC when the steering wheel is rotated from left to right. Press Switch C to lock in the settings. (in Attract Mode) Pressing Switch C shows you how frequently the at- speaker CHAN Sound decrease, the volume until the desired level is achieved. Press Switch C to lock in the setting. Press Switch A to exit this test. CAUTION Atari Games’ field testing has shown that setting the volume too low will cause substantially reduced earnings. 2-3