Ref :UM-CT7-11-001 Issue : 01 Date : 28/04/2011 Page 30 of 35 7.3.6 Connecting to CT7 Especially for the first time connection, you should observe in the lower left corner of the PC screen the case “ connected/non-connected” shown as “connected”. If this is not the case, probably the time- out message will pop-up CONNECTION PROBLEM. Ignore this message and push the button Post Selection Connection to CT7 . A list of active COM ports appears. Most probably the CT7 port is the last one. Select it, pres ACCEPT button: Than try again the connection to CT7 – press CONNECT CT7 button. If connection is established at the left bottom of the screen a message Connected to CT7 will appear in green.
The COM port number is stored, and the next time the connection will be transparent. In case of persisting connection problem see troubleshooting. This document is OPO property. It may not be either used or copied without authorization. OPO sprl, Crawhez 9, 4890 Thimister Clermont, Belgium. +32 87688989 - +32 87598990