Chapter3 Handling 2 Print the prepared data from the printer. 3 Select [Do not print adjustment sheet] from [Adjustment Method], and then click [Start adjustment]. 4 The first Horizontal Alignment window appears. Look at the print results and then select a setting value. After selecting a setting value, click [OK]. If there are gaps (white banding), make the adjustment in the + direction. If there is overlapping in the print results (black banding), make the adjustment in the – direction. The adjustment increment is 0.0105 mm (1/2400 inch). 5 An adjustment start confirmation window appears. Click [Yes]. The second Horizontal Alignment window appears.
6 In the same way as step 4, look at the print results and then select a setting value. 7 When adjustment is complete, a complete window appears. Click [OK]. 8 Print the data prepared in step 1 again. 9 Check the print results. If gaps are no longer conspicuous, the setting is complete. To make further adjustment, repeat steps 3 to 9. Print adjustment sheet 211