Chapter3 Handling Printing on the Last Label There may still be printable labels left when no paper is detected. In order to print on the last label, this section explains how to process the paper. How to Process Roll Paper The following types/forms of paper can be used. • Continuous paper (Black Mark) • Die-cut label (Black Mark) • Die-cut label (Gap) How to process paper • Continuous paper (Black Mark), Die-cut label (Black Mark) Leave a margin of at least 146 mm (5.75 inches) between the rear edge of the paper and the rear edge of the last ticket or label. Less than 146 mm (5.75 inches) from the rear edge of the paper should be liner paper only, with no labels.
When the last ticket or label has been printed, the message "Roll paper is not loaded" will be displayed and the printer will stop. Reload the paper to resume printing. Continuous paper (Black Mark) Roll paper core Die-cut label (Black Mark) Paper feed direction Rear edge of the last label Roll paper core 146 mm (5.75 inches) or more 294 Rear edge of the last la Paper feed direction 146 mm (5.75 inches) or more 146 mm (5.75 inches) or more