Chapter3 Handling Cleaning the Inside of the Printer (when Paper is fed from the Inside) When printing on label paper feeding it from the roll paper set inside the printer, the adhesive of the label paper may adhere to the inside of the printer, resulting in poor print quality. Please follow the procedure below to clean the printer. 1 Turn off the printer and disconnect the power cable from the power outlet. 2 Open the front cover and remove the paper. 3 Remove any adhesive from the roller. Use a cloth moistened with alcohol (recommended: ethanol 80 vol% or less). While rotating the roller by hand, remove the adhesive and clean the entire roller.
4 Remove any adhesive that has adhered to the inner surface of the paper guides. Use a cloth moistened with alcohol (recommended: ethanol 80 vol% or less). • Do not use benzine, thinner, trichloroethylene, or ketone based solvent. Doing so may deform or damage the plastic and rubber parts. • Do not spray or allow alcohol to drip directly on the printer. If alcohol gets inside the printer, it may short-circuit the electronic components or cause deterioration or damage to the components. • Be careful not to allow alcohol to come into contact with any sections beside the areas to be cleaned. CAUTION 304