Appendix Roll Full-page Label Black mark width Paper feed direction Cut position Black mark length Black mark Black mark interval Black mark center position Waste part Waste part Paper Print area • To prevent adhesive from adhering to the roll paper supply unit, use label paper from which the left and right wasted parts are removed. • Since the black mark detector is not located at the center of the paper width, black marks on both sides can be detected no matter which edge of the paper is printed from.
363 Release liner width Cu Bl Label width ter of paper width Item Specifications Without black marks With black marks Paper Type Plain paper, Matte paper, Synthetic paper, Glossy paper, Glossy film, High glossy paper, Texture paper Release liner width 25.4 to 112 mm (1.00 to 4.41 inches) Label width 21.4 to 108 mm (0.84 to 4.25 inches) Waste part on the left and right 2 +/- 0.5 mm (0.08 +/- 0.02 inches) Black mark position - See the above figure Black mark width - 13 mm (0.51 inches) or more Black mark length - At least 4 mm (0.16 inches), With 4 mm (0.16 inches) or more of space around the mark Black mark center position - 8.5 +/- 1 mm (0.33 +/- 0.04 inches) Black mark interval - 8 to 406.4 mm (0.31 to 16.00 inches) Paper thickness 0.159 to 0.240 mm (0.006 to 0.009 inches) Roll core outer diameter 44.1 mm (1.74 inches) or more Roll paper outer diameter Up to 101.6 mm (4.00 inches) Winding direction The side to be printed must face outward Holes and cutouts Paper with holes or cutouts cannot be used