Chapter3 Handling Label print position of data merged using the high speed batch label printing function Label affixing position on the actual media used L1 g G1 L2 g G2 L3 g G3 L4 g G4 L5 g G5 L6 g G6 Check it following the procedure below. 1 Measure the label length of the actual media used [e.g.: L1, L2, L3, L4, L5, L6] and gap between pages [e.g.: G1, G2, G3, G4, G5, G6]. This applies to cases where the distance from the tip of the first label is up to 600 mm (23.62 inches). 2 Calculate the average measured label length [e.g.: L=(L1+L2+L3+L4+L5+L6)/6] and the average gap between pages [e.g.: G=(G1+G2+G3+G4+G5+G6)/6].
3 Check if the calculated average label length L of the actual media and the label length l of the printer driver match. If they do not match, enter the length L for the label length in the driver. 130 l l l l l l W in fi ithin 600 mm (23.62 ches) from the tip of the rst label