Chapter3 Handling Checking How the Print Start Position is Shifted If there is a regularity in the shift of the print start position, such as when the shift increases by 1 mm (0.04 inches) per label, perform the following procedure. "Checking the Gap Between Pages" on page 133 If there is no regularity, the label position may be unevenly distributed. In this case, the high speed batch label printing function cannot be used. Investigate improving the accuracy of the media you are using.
Label print position of data merged using the high speed batch label printing function Regular shift Irregular shift Within 600 mm (23.62 inches) from the tip of the first label Paper feed direction Paper feed direction Paper feed direction Distance shifted by the second label x = a Distance shifted by the third label x ≠ 2 x a Distance shifted by the fourth label x ≠ 3 x a Distance shifted by the fifth label x ≠ 4 x a Distance shifted by the sixth label x ≠ 5 x a a: Distance shifted between the tip of the second label in the merged data and the tip position of the second label on the media actually used x:
Distance shifted between the tip of the nth label in the merged data and the tip position of the nth label on the media actually used 132 Tip position of the second label in the merged data Distance shifted by the second label x = a Tip position of the third label in the merged data Distance shifted by the third label x = 2 x a Tip position of the fourth label in the merged data Distance shifted by the fourth label x = 3 x a Tip position of the fifth label in the merged data Distance shifted by the fifth label x = 4 x a Tip position of the sixth label in the merged data Distance shifted by the sixth label x = 5 x a