Chapter3 Handling 5 An adjustment start confirmation window appears. Click [Yes]. The second Horizontal Alignment window appears. 6 In the same way as step 4, look at the print results and then select a setting value. 7 When adjustment is complete, a complete window appears. Click [OK]. 8 Print the data prepared in step 1 again. 9 Check the print results. If gaps are no longer conspicuous, the setting is complete. To make further adjustment, repeat steps 3 to 9. Print adjustment sheet 1 Load die-cut label, continuous paper, or full-page label paper with a length of 66.7 mm (2.63 inches) or more into the printer.
2 Select [Print adjustment sheet] from [Adjustment Method], and then click [Start adjustment]. 3 A confirmation window to print the adjustment sheet appears. Check that paper is loaded in the printer and then click [OK]. The adjustment sheet is printed and the first Horizontal Alignment window appears. 4 Check the sheet and then select the number for the pattern with the least gaps or overlapping in each of #1 and #2 groups, and then click [OK]. Adjustment sheet print example (for this sheet, select “0” for both #1 and #2 groups.) 5 A confirmation window to print the adjustment sheet appears again. Click [Yes].
The adjustment sheet is printed and the second Horizontal Alignment window appears. 208